Your cart is empty.
Your cart is empty.This Aftermarket Tapue Single Gauge A-Pillar Pod is specifically designed and color matched to your 2003-2009 Dodge Ram Cummins, and will mount one 2 1/16th inch (52mm) gauge directly to your vehicle’s A-pillar for a custom fit and finish. GlowShift’s 2003-2009 Ram single pillar pod is manufactured from high quality ABS plastic, allowing it to withstand cracking, fading, and warping. GlowShift includes mounting hardware, installation instructions, and a one year limited warranty with every pillar pod purchase.
Coryjr
Reviewed in the United States on March 13, 2024
Gauge pod is doing great. Looks and installed nicely.
Jeff of Howe Texas
Reviewed in the United States on November 27, 2024
worked perfectly on my 2008 ram 3500.had to slightly inlarge the push pin holes to be able to snap them in. Looks factory!
Daniel ward
Reviewed in the United States on April 6, 2024
Works like is should. Was a little bit of a pain to melt and form to the piller but so far it's ok.
DIY661
Reviewed in the United States on March 13, 2023
Easy install.
James & Jennifer Coogler
Reviewed in the United States on July 17, 2021
Worked just as intended and color matched great
Customer
Reviewed in the United States on January 29, 2021
Great color match, Awesome design
robert brockmeyer
Reviewed in the United States on March 1, 2014
Nice fit on the a-pillar of the Dodge.Also the color match was pretty good.Looks great and the gauge fits perfectly.
Jaden
Reviewed in the United States on November 21, 2014
I give this only 2 stars because even at the relatively low cost i was surprised how dissapointed i was. Sure it holds a gauge against your a-pillar (I have a 2004 Ram 1500 which I believe has the same interior components as 2500-3500 cummins), so it performs as intended, but it could easily be so much better. The color is not a great match, but is ok. The texture doesn't match at all. It could fit around the a-pillar much better or snap on (instead your supposed to use 4 provided screws). It is also much larger than it needs to be (the gauge could be held much closer to the pillar, allowing the pod to sit lower and closer to the dash). I am not using the screws to hold it in place, since i'm not satisfied with it for interior look and fit. Instead i have it held in place by resting it on the top of the dash. If you're someone who is particular about your interior, I would not buy this item. If all you need is something to hold a gage on your a-pillar, and don't care about looks, then this item or a smaller gauge holder bracket is for you.
Recommended Products
$59.99
$ 30 .99 $30.99