Eddie Reaves
Reviewed in the United States on June 24, 2024
This was exactly what I was searching for. Excellent seller. Would buy from again.
Anthony
Reviewed in the United States on September 3, 2022
no tools required, except two sided tape and a scissors, i digress, it's simple to install, simple to configure with the OSD, and simple to get audio from (3.5mm headphone jack)plus besides the listed screens, I've gotten success with others of the same resolution and pin connection,would recommend
Pedro
Reviewed in the United States on February 24, 2022
Just got it set up as of this review and so far it appears to be working well. I paired it with an N140BGE EB3 panel from an old Lenovo. It came in a clean cardboard box roughly 3cm x10cm x15cm. The Main board and smaller board were hooked up out out of the box and in a smaller bag I found two 25cm ribbon cables that fit well on both ends. I am running it on a 12v 2a power adapter which seems to work just fine.The one thing that I would consider thinking about is where to attach the boards and how to enclose them (if necessary, I just left mine open).
MTXRooster
Reviewed in the United States on May 19, 2021
EDIT: For those using this on the mentioned panel below: DO NOT USE THE ORIGINAL CABLING OFF THE PANEL, USE THE SUPPLIED CABLE!!! Disregard the below portion, panel is working WITH THE SUPPLIED RIBBON CABLE (lol)..I bought one of these to use on a known-good N116BGE-EA2 panel, and it's not working. When I power it up (with a 12v4a power brick) it flickers orange (red and green) then goes to red for 3 seconds, then the light shuts off for a second and the process repeats over and over. Doesn't matter whether I have an HDMI input plugged in or not, nothing happens/comes on at the panel, which was verified known good as I mentioned before. I actually have access to numerous of the same panel, and for good measure tried others to no avail. Any ideas?
Daniel Alexander Bautista Padilla
Reviewed in the United States on January 5, 2021
Really happy with this purchase, the board was really well packaged (i ordered the same one before from other seller and it wasn't even in a properly closed box), amazing value adding the ribbon and a spare, even came with instructions, and of course the board worked fine out the box ( sadly i've encountered other ones that didn't from other sellers )
Jason Tremblay
Reviewed in the United States on August 3, 2020
I'm currently using this to control a laptop screen embedded in a virtual pinball cabinet, and it seems to be doing a fine job. However, since this is a bare board, everything about it feels very delicate. Connecting the cables was a little nerve-wracking due to their thinness and my giant fingers, but I eventually got it all connected and functioning. I've only been using it for a few weeks, so I can't speak to its durability, but it's doing well so far. Be patient during installation, and go in with a plan for how you'll mount it safely.
M
Reviewed in the United States on June 9, 2020
In general it works out of box. It works with my LED screen. The board relays hdmi audio to a audio headphone jack. However, the audio output is for headphone, not for speakers. When the audio was fed to amplifier, noticeable humming sound came out of it even when volume is set to 0
Anomander Rake
Reviewed in the United States on June 10, 2018
Very, very happy with my purchase. I inquired about my specific panel number to double check and I received a very prompt and helpful response which led to me purchasing. It works beautifully and is very easy to install. Love that it also has a 3.5mm audio out jack on it, especially when using with a Raspberry Pi, whose onboard audio is terrible. Highly, highly recommend.