Shopping Cart

Your cart is empty.

Your cart is empty.

KAISH Pack of 10 American Thread 15/32' Fine Knurled Guitar Toggle Switch Nut for Les Pauls with Switchcraft Switches Black

Free shipping on orders over $29.99

$8.99

$ 3 .99 $3.99

In Stock

1.Color:Gold


About this item

  • KAISH USA sized Toggle Switch Fine Knurled Nut
  • This is NOT a "deep" thread nut, but the standard nut
  • Fits Switchcraft 3-way toggle switches which used on most USA Gibson Les Pauls
  • SAE 15/32-32 threads; This is KAISH's after market part, not original switchcraft nut
  • Package includes 10 nuts


KAISH Pack of 10 American Thread 15/32" Fine Knurled Guitar Toggle Switch Nut for Les Pauls with Switchcraft Switches Black


Richard M.
Reviewed in the United States on July 20, 2024
It is not the right color but it gets the job done!No Radio Shack? Find this part on Amazon!
Mike Spigut
Reviewed in the United States on March 10, 2024
I used this on an 80s MIJ Fender toggle switch. Finding an original was difficult and they all looked rough. This fit perfect and has very similar ribs around the edge. It is slightly thicker than the original but I doubt anyone would notice.
Dave
Reviewed in the United States on February 6, 2024
works perfect when the plastic rings break
Brian M
Reviewed in the United States on November 30, 2024
This thing are just cheap quality. The gold is too yellow and it scuff easily.
Loafing Joe
Reviewed in the United States on September 11, 2023
Review updated. Apparently, either the Studios used metric switches, or mine was swapped for metric at some point. The 15/32" but threads on this product are correct. Rating updated.Did not fit the switch on my '95 American Les Paul Studio. It would start, and then bind - would not tighten down. Don't know if it is a mislabeled batch, if the gold color plating is too thick, or if the threads were not machined with enough clearance to work with plating. Had the same issue with the Kasich collared nut that was supposed to be 15/32".
Customer
Reviewed in the United States on July 31, 2023
These are for switch, but I needed for mic stand. A little less to grip, but do the job.
Sven L.
Reviewed in Germany on October 31, 2023
Ich brauchte neue Muttern, da meine alten vom Boot aus Kunststoff waren und mit der Zeit gebrochen sind.Sie passen perfekt auf die vorhandenen Schalter.
Jon
Reviewed in the United States on October 19, 2023
Great replacement nut for toggle switches.
Diane Howle
Reviewed in the United States on September 9, 2020
Good quality. Power coated brass.