Your cart is empty.
Your cart is empty.The Thermocut Fence TA 300 is a precision tool designed to elevate your woodworking projects to the next level. Crafted with meticulous attention to detail and engineered for excellence, this fence is your gateway to enhanced precision and efficiency in the workshop. Constructed from premium aluminum, the TA 300 features a finished working surface that ensures ease of movement and precise cuts. Whether you're a professional carpenter or a DIY enthusiast, the smooth surface of this fence makes every task a breeze. What sets the TA 300 apart is its versatility in angle settings, allowing you to choose any angle between 0 and 90 degrees. To further enhance your precision, the fence includes an integrated T-slot with an additional angle stop. This combination enables particularly intricate cuts that demand the utmost accuracy. No matter the complexity of your woodworking project, the TA 300 ensures flawless results. Built to meet the demands of professionals and hobbyists, the Thermocut is a testament to durability, efficiency, and precision.
David dd
Reviewed in Belgium on March 3, 2025
Goed toestel, geen opmerkingen.Vooral gebruiken waarvoor het dient.
Mykola
Reviewed in Germany on January 6, 2025
good device
Jessica Barns
Reviewed in Canada on January 27, 2025
The actual wire cutter is not included even if the picture does seem to imply it does.
Mrombit
Reviewed in the United Kingdom on January 1, 2025
Bought this expecting side parts can be swapped to use it on right side of the hot wire. Not possible unless you 3D print your own parts instead of the stock ones. Would be good if that can be mentioned in the description / user manual. Otherwise - good quality and works OK.
Nicholas Lewin-Koh
Reviewed in the United States on June 7, 2024
The overall combination of the angle cutting with a fence is quite nice and combines 2 tools in 1. I haven't had a chance to work much with the angle settings, so can't comment. Using it as a replacement for the stock fence, some problems come to light. The fence has the gap for the wire to pass through, and the back of the fence does not have a rigid support so there is a little bit of flex to the fence and pieces of foam can catch in the gap. Also there is a 2cm gap at the bottom so you cannot cut flat pieces with the fence as is. Lastly the fence rail sits very tightly in the groove holding it in place and it cannot be loosened, so you. have to pull it out of the groove to move it, so it is a pain to reset the fence for a new cut. It would have been much better if proxxon had designed it with a mechanism to tighten and loosen it.I solved the first 2 problems by cutting a piece of 5mm mdf to fit over the fence and glued on a thin piece of mdf that fits in the groove so there is a flat fence surface.So overall it needs some tweaking and fiddling to get right.
Luigi D.
Reviewed in Italy on April 23, 2024
Ottimo
Recommended Products
