Your cart is empty.
Your cart is empty.Aaron P
Reviewed in the United States on June 4, 2021
Worked perfectly on my ‘93 Fourtrax! Quick tip when replacing these, use your old cable as a means go guide the new cable into place. I use a good electrical tape (3M Super 33 is my favorite) tape the brake lever side of the new cable to the back of the old cable, pull the old cable out while pulling the new cable in!! Works like a charm!
jennylee
Reviewed in the United States on February 16, 2020
Inner cable has no plastic coating.It is this which always concertina,s and causes cable to jam.Also has some stretch and this makes it so much easier to set and adjust the hand brake.Very pleased so far.
BigBluRvrCat
Reviewed in the United States on April 6, 2020
Easy, fast replacement, and works like it's suppose to. FYI the cable is not rubber coded like the original OEM cable. I don't see it lasting 23 years like the one I replaced.
Jeff
Reviewed in the United States on April 25, 2020
Fit and worked well on my 94 trx300
a12
Reviewed in the United States on December 19, 2019
Perfect fit, fast shipping. Plenty of brake feel now, better than new!
Chris W.
Reviewed in the United States on December 12, 2019
Fit perfect and seemed to be heavier design than original.
Customer
Reviewed in the United States on December 10, 2019
Product was just as described. Perfect fit for my 95 fourtrax 300
C.M.
Reviewed in the United States on October 30, 2019
Seems good so much better then the old worn factory one. So far I’ve only had it on for a day length was good but the rubber boot on the lower portion was a bit too short.
Recommended Products