Your cart is empty.
Your cart is empty.The Raypack Inc Pilot Natural/Propane Iid is designed to last. It is made from quality materials and has been tested in a rigurous quality control process. Reference model number: 002003F.
DThat
Reviewed in the United States on February 24, 2025
I had to replace the igniter in my pool heater. This part worked perfectly.
Up North "Rich"
Reviewed in the United States on June 7, 2024
I have had my pool heater for 3 years and the heater this year would fire and then stop with an ignition failure code. Pulled the hater out, cleaned the gas jets and replaced the igniter switch. Works just like new and very easy to change.
Judith Smith
Reviewed in Canada on May 27, 2024
This was a Raypak replacement part. Perfect fit, fixed the problem and cheaper than any pool store on my area!
Mikethepoolguy
Reviewed in the United States on December 14, 2024
The media could not be loaded.
Terry Graham
Reviewed in the United States on September 26, 2023
This is a factory part with a reasonable price. So far so good.
Eric S
Reviewed in the United States on August 11, 2023
I installed this (along with the pilot supply tube - Raypack 004078F Pilot Tube Spa Pak 53A) on our Raypack pool heater model P-R406A-EN-C. The part comes with good installation instructions including pictures.Our pool heater wouldn't fire up - it kept cycling like it was trying to fire, but it wouldn't. I believe it was because the heat sensor on the pilot assembly was shot. Replaced (less than 1-hour work) the pilot assembly, tested for leaks (soapy water) and everything works perfectly now (been working for two months so far without issue).
russell frank
Reviewed in the United States on September 10, 2016
worked great after calling the heater company to figure out why it was not working. turns out the orifice was lose in the package rather than in place in the unit. the instruction relating to the orifice were a little vague.
Peter Mueller
Reviewed in the United States on August 5, 2016
This did the job on my RayPak 2100. I had been advised by generally knowledgeable people to look for a 'bad thermocouple' - a separate device that's present on most gas systems to tell the main valve when it's safe to let gas through. I searched high and low for one, but couldn't find one on my unit. It turns out, this little self contained unit reports back to the motherboard whether or not the pilot is on (and therefore safe to open the main valve.) It took less than an hour to remove the old one, and put this one in. I would say that if you're not seeing your pilot light (or stay lit) and the heater's not complaining about anything else (like a flame-out, which would indicate some sacrificial fuse needs replacing), then it's a good bet to go ahead and replace this part.
Craft Engineer
Reviewed in the United States on January 15, 2015
Installed in a mid-nineties Raypak Versa 185-405C, where the original one had rusted to the point where the it was no longer reliable. Item comes pre-configured for natural gas with an extra orifice for propane. The brass piece includes an integrated compression fitting for 1/4" OD aluminum tubing. I also replaced the bracket and pilot tube at the same time. Instead of using the Amazon recommended Raypak tubing (which doesn't appear correct for this application), I used the multi-application RobertShaw 11-293 1/4" pilot tubing, which was perfect for this application and came with the correct fittings for my gas valve.The unit I received had a white wire instead of the pictured blue, however the color is not a concern. I am a bit uneasy with the thickness of the insulation as compared to the original piece, but it appears to work reliably so far. Item includes a piece of rubber hose to insulate at the ignition module.
Recommended Products
