Your cart is empty.
Your cart is empty.Product Description
RC Rear Bearing Kit for 1/10 RC Crawler Car Axial SCX10 90046.
Features:
- Fine workmanship and perfect style.
- Perfect for model car lovers.
- Increase the authenticity of your RC car.
- Easy and convenient to install and remove.
- Suit for 1/10 RC Crawler Car Axial SCX10.
- Package List: 2 x Rearview Mirrors with LED
How to install
- Remove the original rearview mirror. Then insert the rearview mirror wire into the original hole.
- Use a blade to remove the plastic covering on the clamp wire, and then insert the clamp wire into the hole in the center of the two round fittings. Pay attention to the direction of the round fittings, with the concave surface facing the outside of the car door and the flat surface facing the inside of the car.
- In the above steps, after threading the thread, cut the hole on the door. Cut off about 3mm from top to bottom.
- After cutting, install the screws. Do not install the screws too tight. Because it is a 3D printing material, it cannot be subjected to too much force and will not come loose. Then replace the original plastic clamp housing.
- Finally, turn on the 4.8V~6V power supply or connect to the reserved channel of other lamp groups. During installation it may be necessary to cut the inner lining. (This depends on the actual situation)
Jon W
Reviewed in the United States on May 26, 2023
Too big for 1/10 Scale. Terrible printing, you can see lines in them. Absolute nightmare to mount you have to disassemble the electrical connections and feed them through your body then reassemble after mounting.
Recommended Products