Your cart is empty.
Your cart is empty.Product Description
3V1-06 Solenoid Valves
Product Parameter
- Type: 3 Way 2 Positions
- Inlet = Outlet = 1/8"NPT
- Pressure Range:25-116PSI
- Temperature Range: 0-140°F
- Operation Type: Internally Piloted Acting Type.
Please Pay Attention To Whether The Installation Conditions Meet The Technical Requirements (such As Voltage, Working Pressure, Temperature Range, Etc.), And Then Install And Use.
Product Packaging
MountainMan
Reviewed in Canada on June 28, 2024
Great for the price
Donald J. Bezek Sr.
Reviewed in the United States on May 18, 2024
Nice device being used for temperature control at a church. Replaced a pneumatic thermostat with electronic that controls the solenoid. Also purchase 24VAC to 12VDC for solenoid coil.
gus
Reviewed in the United States on October 7, 2024
Fittings are bad they will leak. Don't even bother. Get some dot they have a guide inside for the tube that won't leak. But unit itself didn't work for me.
Jon
Reviewed in the United States on September 21, 2023
found these were not proper for our needs.
Misha
Reviewed in the United States on October 27, 2023
Wrong valve. Two inlets, one outlet, diagrams incorrect.
Eric
Reviewed in Canada on October 24, 2023
This is a 3port 2 way 2 position valve. Otherwise known as a 2 way valve. Both outlets are the same port, there is no third way for air to travel. I needed 3 way. Not happy. So tired of people not having a clue what anything there are selling is.
Mike Pearson
Reviewed in the United States on August 12, 2021
So I initially thought this item was defective until I did more research. This item is a “pilot operated” valve. I was using this to operate an air cylinder and the main premise of a “pilot operated” valve is that the outlet must be of lower pressure than the inlet. This cannot happen in a air cylinder as the pressure equalizes.I ended up getting a “direct acting” valve that does not have a pressure imbalance requirement.After my research and understanding how both types of valves work, I realized that this valve is built correctly and will work in the correct application. Buyers should be familiar with how this valve normally works before buying as it is easy to just to assume it just doesn’t work.The valve is of good quality, it just wasn’t the right valve for my application.Seller was very prompt on customer service and if I need this specific type of valve in the future, I will buy from this seller again.
Russell Blackburn
Reviewed in the United States on July 18, 2021
I made an air soft sniper rifle. The contact for the trigger is so much easier than a trigger pull so u have less chance of error. Perfect for air soft or paintball.
Collin N.
Reviewed in the United States on October 11, 2021
Bought 4 of these solenoids for various compressed air functions on my truck. One to add and one to let air out in air bags for increased towing capacity, one for an air horn, and one to drain the entire system(tank) of pressure. For whatever reason after about 50 psi, they stop working like they can't function at a higher air pressure. 50 psi works fine for what im using them for but I had to put a regulator on the system. When they start to quit I'll probably find a strong solenoid.
AJ Ferrick
Reviewed in the United States on June 16, 2020
Bought this as a replacement for one I had that went bad. I got about 3 years out of the first one. The electric side of it was fine, but it recently started to let air pass through it. Overall I'm happy with it. Does what I need it to do, and $12 to replace it, isn't bad at all.
Recommended Products