Shopping Cart

Your cart is empty.

Your cart is empty.

TOBWOLF 1 Pair MTB Disc Brake Set, Hydraulic Disc Brake Kit with 160mm Rotors, Left Front 81cm & Right Rear 147cm, Aluminum Oil Pressure Calipers Levers for Mountain Bike E-Bike Fat Bike Road Bike

Free shipping on orders over $29.99

$42.99

$ 20 .99 $20.99

In Stock
  • 【Important NOTE】-- This set works on the principle of Left Front and Right Rear, which means the left lever controls front wheel brake, while the right lever controls rear wheel brake. The position of front and rear brake operation may vary due to different people or regions. You may switch the brake cable based on your actual needs. (Using a wrentch and a plier to disassemble the brake cable and swap the sides. There might be small amount of oil leakage, but it doesn't affect the usage.)
  • 【Installation Instructions】-- Make sure the calipers and pads correctly fitted to the hub and aligned with the disc. Adjust the clearance and fine tune the brake adjustment screws to ensure good braking without clicking. Exhaust the hydraulic disc brake system to maintain optimum performance. Pull the brake handle to test if the brakes are contacting the disc to make sure the braking effect is normal. (Kindly contact us to send you the user manual. Also check the video on this detail page.)
  • 【Upgraded Ceramic Brake Pads】-- The ceramic brake pads will not damage the disc, and further improves the braking effect. Please remove the caliper protection sheet before installation. This hydraulic disc brake kit is constructed using high grade aluminium alloy, not only no squeaking from the brakes rubbing, high temperature resistance and anti-breaking, will not affected by extreme weather like rain and snow.
  • 【Stainless Steel 6-Bolt Disc Rotors】-- Ultra-light rotors that shed weight and shred trail, while still achieving superior braking power and modulation. With massive vent holes throughout the spider, and drilled holes through your contact patch to help both with heat vetting and weight shaving.
  • 【Widely Compatible】-- It comes with sturdy steel fasteners and will work with any 6 bolt compatible hubs. Suitable for most mountain bike, road bike and hydraulic disc brake system. Please make sure whether the hose is long enough before purchasing.(**Left-Front Tube Length: 81cm, Right-Rear Tube Length: 147mm. )



Product Description

J19587-A01

A Few Warm Tips on Minimizing the Noises Made By Hydraulic Disc Brake

1. If you have ridden fewer than 300 km on your bike, the brakes are not yet fully ridden in. In this case it is very probable that the noises will go away themselves if you ride more.

2. A common cause for squeaking disc brakes are dirty brake rotors. To clean them, take the wheels out and clean the rotors thoroughly with water or a special cleaner from a good bike shop.

3. Check if all bolts and screws connecting the hub body to the brake rotor are correctly tightened.

Package Included:

2 x oil pressue cylinder driven caliper

2 x aluminum bicycle brake handle lever

2 x 160mm 6-bolt disc rotors

12 x titanium bolts

4 x fixing bolts

J19587-A02

J19587

Upgraded Brake Pads

Will not damage the disc, and further improve the braking effect.

J19587-02

Sufficient Length of Hose

Left-Front Tube Length: 81cm

Right-Rear Tube Length: 147cm

J19587-A05

Compatible with Most Bikes

The lever fits most common handlebar of 0.87inch(22mm) in diameter.

J19587-A06
Customer Reviews
4.3 out of 5 stars 656
4.2 out of 5 stars 138
4.7 out of 5 stars 1,350
4.1 out of 5 stars 270
4.3 out of 5 stars 417
4.0 out of 5 stars 23
Price $13.49 $13.49 $17.90 $17.99 no data no data
Product Name Mini Bike Rear Pedals Bicycle Brake Levers Shifter Black Self Adhesive Bandage Black Inline Skate Wheels 25x45cm Cargo Storage Net 3 Layer Vertical Ball Storage Rack

Feliz Tovar
Reviewed in the United States on March 3, 2025
Very easy to install. Nice update to my brakes. I needed to replace my isinwheel bike brakes and these worked perfectly!
David78212
Reviewed in the United States on February 4, 2025
Great full set of basic hydraulic brakes. But you should know how to work on hydraulic brakes, I had to replace the rear hose to run it through the frame. You need to pay attention to the house length, mine was a tight fit but it still fit. I replaced the factory brakes which just stopped working, but I had the tools I needed to work on hydraulic brakes. Ah yes, the old argument of hydraulic vs cable. Both are easy to work on once you have the tools you need. Cable brakes don't need many tools.
Julian
Reviewed in Canada on January 30, 2025
Amazing feel out of the box, I’m hoping they hold up well. Big upgrade from mechanical brakes at around 60$ these are really nice. Time will tell how they hold up but build quality is perfect for entry level hydraulic brakes. Even with my original disks these brakes bite hard and stop me much quicker on my fat tire bike.
Jeff Downing
Reviewed in the United States on September 5, 2024
Replaced OEM on an e-bike for front brake. Easy swap and after a couple months of use work as well as ever.Good price for very good quality.
sean
Reviewed in the United States on September 18, 2024
Right after I opened the box I noticed that the bags holding the screws had nothing in them and one of the levers look like it was dropped. I still installed them on my bike but being beaten up looking on arrival drops a star for me.I was able to change the set up from left to right easy enough as these are set up different than what I am used to. Either way swapping the cables was easy. What was not as easy was trying to get the cable off the brake itself. I had to do that to run the cable inside my bike frame but all that ended up happening was the screw holding the cable into the brake rounded. I ended up stopping before ruining anything and just routed the cable outside the frame.I ended up having to add a little oil after the swap and trying to route the cable inside the frame but i figured I would have to do that. This was easy to do with these brakes.So far the brakes seem fine. They stop the bike and there is plenty of stopping power in them. So no issues with functionality.
Tim
Reviewed in the United States on August 24, 2024
Installation was very easy (no instructions, or user manual is the reason for 4 stars). Stopping power is so much better than my old cable set up. All the hardware is included. The only thing that might be a problem for some people is that the handles are reversed, which can be changed if you want to switch the lines from left to right. Just wish they would include installation and user manual. I would recommend these as long as you are mechanically inclined.
Glen Buterol
Reviewed in the United Kingdom on February 9, 2024
I am new to disc-braked bikes. I pulled too hard and locked up the original disc-brake. I went over the handlebars, the front wheel fell off, the disc bent, the pads tore, the fork twisted. Catastrophe. Lesson learned, adjust front brakes so that a minimal pull is insufficient.I ordered these (two discs, two calipers) even though I only needed one disc. No harm to have a spare set, and I thought the original caliper must have sustained some damage when locking up and twisting in the accident.The new disc and caliper were easy to fit, and allowed sufficient adjustment for a rub free fit.I liked also that the supplied screws were pre-daubed with blue thread lock.I straightened the fork.
Boneshaker
Reviewed in the United States on December 24, 2024
First off, the handles came American style. Meaning front brake on the left rear brake on the right. Unlike some other reviews my product came unscratched unused and sealed in its packaging. It was in perfect condition. I believe that a lot of these companies have issues with quality control versus the actual products being bad. I wasn't sure about the long handles but after using them I realized that if you're a one finger breaker and you set the handle for your finger to land right at the end it gives you a ridiculous amount of modulation control. Far more control than I've ever had on the shorter single finger or two finger levers. Also unlike other breaks I've tried, these have not leaked at all. I've bled them twice since I've gotten them just to see if any air is getting in. It was so minimal it wasn't even really worth mentioning.All in all, for 40 bucks these are definitely worth it. Provided you get a set that was checked before it left the warehouse. The last breaks I had were the zoom breaks and I had to order them twice because both times the handles were leaking hydraulic fluid. These are actually good brakes. If they can support me hopping on my front or back wheel, then they're doing about as much as they need to. I highly recommend
Thomas Campbell
Reviewed in Canada on November 19, 2024
Excellent delivery this is what I ordered,thank you kindly
michael s.
Reviewed in Germany on February 7, 2023
Bis jetzt super
Chris Barker
Reviewed in the United States on December 21, 2023
I've only just started using these brakes and I like them very much for the price. I used to run cable pull hydraulic brakes and they worked well but these kick them in the butt. I mean for the price the stopping power is unmatched compared to the line pull. Like I said I haven't had a good run at these and I will update the review in a few months or sooner if there is a problem. The brake leavers are not North America standard. Meaning, the left brake is for the rear and the right brake is for the front. I specifically searched for this configuration because I find it relevant to my style of riding. So be aware of this before you order. Seems some people don't read the description and when they receive them they freak out because the are opposite. They are solid and stop great.
heckmann
Reviewed in France on April 15, 2023
de tres bon frein pour du cable
Recommended Products

$45.99

$ 21 .99 $21.99

4.8
Select Option