Your cart is empty.
Your cart is empty.The M86 Universal Rack Steering Cable is the one and only cable that directly replaces Uflex, Teleflex SC124 "The Rack" and Morse Command 200 steering cables with no adapters. This cable features solid stainless steel engine output fittings for enhanced longevity and durability. The armor wrapped stainless steel core delivers the ultimate in efficiency with minimal lost motion.
Michael Betts
Reviewed in the United States on July 1, 2024
I used this to replace my original 1976 steering cable setup on my jet boat. works great!
G Downing
Reviewed in the United States on October 30, 2024
Fast delivery and part description was accurate match and measurements to my old 1992 model cable that is discontinued. This is the only interchange I was able to find on-line. Installed it and steering is now as good as new. Be sure to apply a little lube to the O-ring and cable nut seal when installing the new unit and use marine grease at the engine mount fittings. Thanks!
Eric Lee
Reviewed in the United States on June 25, 2023
U-Flex products are good,less expensive than Teleflex/Dometic. Wish the vendor was a Prime shipper.
Tba
Reviewed in the United States on July 5, 2022
The bolt holes for steering wheel shaft housing did not line up with rack on the steering cable, measure your holes before you order it !! Says universal, but its not
Placeholder
Reviewed in the United States on September 10, 2021
This cable was suppose to replace factory Rinker Teleflex steering cable. As you can see in photos the flange runs whole length of rack. It not being narrow like old one wouldn't allow it to go over the helm gear.
Floyd Hochstetler
Reviewed in the United States on August 5, 2021
Worked perfectly on my 1997 crownline 202br
Recommended Products
