Your cart is empty.
Your cart is empty.IMPORTANT UPGRADES:1. Instruction included. 2. Clamp upgrade, so no more popping off.
- Forrie--your Best Choice for aftermarket intake manifolds
- Precisely engineerd for durable service
- Perfectly match the fit of original part on specified vehicles
- Thoroughly tested for superior reliability
Fitment Tabel: This item Compatible with below Vehicles
2007-2008 Ford F-150 V8 281 4.6L; VIN W
2007-2008 Ford E-150 V8 281 4.6L; VIN W
2007-2008 Ford E-250 V8 281 4.6L; VIN W
2007-2008 Ford Lobo (Mexico) V8 281 4.6L
Eric
Reviewed in the United States on March 21, 2025
excellent quality
Thomas Sourbeck
Reviewed in the United States on June 9, 2024
Great product! Got my truck back on the road. Check the tightness of the hose clamp on the heater bypass plug.
Luis ortiz
Reviewed in the United States on March 18, 2024
Loved exac fit
Gene butcher
Reviewed in the United States on May 23, 2022
Great deal
Jfairser
Reviewed in the United States on March 8, 2022
After installation, the rubber boot on rear of manifold blew off with just pressure from water pump. Original equipment did not have a rubber boot. Clamp privided was not sufficient to hold boot. Many of the original bolts were replaced with self taping screws. Poor quality. Many parts left over. Since no instructions, you have no idea what they are for. Not recommended
James L.
Reviewed in the United States on December 1, 2022
Was easy and to install if you know your basic mechanics and your way around a little bit the gaskets weren’t glued so they were kind of loose on some of them but everything basically fit and so far so good they did upgrade the spring on the back with a cap and they had a washer on it which was good I doubled mine up because all the reviews I seen about them popping off but yeah good product so far it’s been about two months get me back on the road
Larrydwiker
Reviewed in the United States on August 10, 2021
Very good would buy again
Rossco
Reviewed in the United States on November 30, 2021
Was smaller than 4.6 v8 OEM. But mine had a leak. This one was half the money. It is smaller in volume, and doesn't have metal threaded inserts. All plastic screw holes. And, there is an extra port with a rubber cap with a spring clamp. Make sure to use a hose clamp. I didn't, and it blew all my coolant out. Basically fits.
TA22
Reviewed in Canada on November 12, 2021
The manifold is a very different design than original but it did fit. You will need to re-use your factory alternator bracket and modify the two rear holes to fit as the ones sent interfere with the throttle body. There is a plug that is installed on the back right corner to cap a coolant tube...that cap/plug broke on the test drive caused all the coolant to come out rapidly.
Recommended Products
$273.99
$ 99 .00 $99.00