Shopping Cart

Your cart is empty.

Your cart is empty.

YG-1 Z9 Series Vanadium Alloy HSS Roll Form Tap with Oil Groove, Uncoated (Bright) Finish, Round Shank with Square End, Bottoming Chamfer, M5-0.8 Thread Size, D7 Tolerance

4.7 (2) Write Review
Free shipping on orders over $29.99

$19.05

$ 8 .99 $8.99

In Stock
  • High-speed steel tools are good for most general purpose applications, offering a combination of hardness and toughness for wear resistance
  • Uncoated tools feature just the base substrate without any additional treatment or coatings and are suitable for a wide range of applications
  • Round shanks allow use with a wide variety of toolholding systems
  • Straight flute tools allow chips to collect in the flutes as they cut and are well suited for most applications in shallow cuts
  • Right-hand cut tools have a cutting action that engages when they are run in a clockwise direction


YG-1 Z9 series vanadium alloy HSS roll form tap with oil groove. High-speed steel tools are good for most general purpose applications, offering a combination of hardness and toughness for wear resistance. Uncoated tools feature just the base substrate without any additional treatment or coatings and are suitable for a wide range of applications. Round shanks allow use with a wide variety of toolholding systems. Straight flute tools allow chips to collect in the flutes as they cut and are well suited for most applications in shallow cuts. Right-hand cut tools have a cutting action that engages when they are run in a clockwise direction. Applications: Excellent for low carbon/free machining carbon steel, medium to high carbon steel, free machining stainless steel, pure aluminum/aluminum alloys, aluminum alloy castings, pure and alloyed copper, free machining brass/alloyed brass, zine, magnesium.


roptics
Reviewed in the United States on June 20, 2024
This has been so much easier to use than a cutting tap. Not only is it easier to use but the threads are stronger because they are work hardened while forming. I am only using this with aluminum so i have no ideas how or if it works with steel.
Daniel Bengtson
Reviewed in the United States on October 24, 2023
I was trying to tap some aluminum prototypes and it grabbed and broke off in one of them. I should have used the right tap for the job.. decent quality tap.