Your cart is empty.
Your cart is empty.Product Description
All accessories are finished by machining center to ensure accuracy. And the surface is anodized for better impact resistance, wear resistance and long life.
- Step angle: 1.8 degree
- Motor flange size: 57mm
- Motor length: 56mm
- Holding torque: 1.2N.m
- Current: 3A
- Resistance: 0.8 ohm
- Inductance: 2.4 mH
- Rotor Inertia: 440g.cm
- Lead wire: 4pcs
- Wiring: Red: A+； Green: A-; Yellow: B+; Blue: B-
Movable nuts on the back and sides for easy fixing and installation of limit switches
High-precision 1605 type ball screw, with flange screw nut, the accuracy can reach 0.003mm, it can be used under high speed and large load, and the operation is very stable.
Two 12mm guide rails, with precision ball screw, horizontal load 60KG / 132.28 Ib, vertical load 30Kg / 66.14 Ib, Max. Speed 100mm/s,2inch/s. Linear guides are used as guides to ensure straight running and load capacity
Thickened bearing bracket, the slider is more stable in operation, and the screw is not easy to shake
ChetHardrock
Reviewed in the United States on February 25, 2025
We ordered the same part numbers (identical part numbers) about a month apart but received two different geometric configurations. This inconsistency has caused delays in our project timeline, as we expected identical parts.Additionally, the second part appears to have been used before.Please clarify whether there have been design changes or if this was a fulfillment error.
Andres Guevara
Reviewed in the United States on January 3, 2025
Excelente producto
DaveS
Reviewed in the United States on June 22, 2024
Built well. Sturdy, no slop on the bearings. Be aware, mounting hole dimensions are 30 mm x 60 mm. 5 mm thread size.
MotoCue
Reviewed in the United States on January 28, 2024
This is a great product bolted right up to my 3020 . Couple things to note it is a four slot in the back versus my three so it is over one slot, which is not a big deal for me. Also, the bolt pattern for most of the router mounts does not match up. It’s off on both sides so I drop it down and drill the new set of holes. It should be 30mm x 70mm and it’s not , but that’s not the end of the world for the price and quality. I I did put my stock Nema 17 on the top and there was no modifying to do that. It bolted right up as There was an extra set of holes.
Tyler Grachan
Reviewed in the United States on April 16, 2024
I was hoping to replace the z axis on my DIY CNC machine with this but the rail blocks had way too much play to even be remotely usable. After mounting the spindle, I was seeing almost 1mm of deflection at the bit due to the linear rails and blocks having quite a bit of play. Depending on your use case, it might be fine but for my intended design, it was a fail
Heather
Reviewed in the United States on April 8, 2023
I received the item quickly and as described but the quality of the item is not acceptable IMA. the linear rails only have every other screw making them more likely to bend or break.
Recommended Products