Your cart is empty.
Your cart is empty. Our new semi-direct solenoid valve series, constructed from industrial-grade brass or stainless steel, provides optimal performance for high-temperature projects and is compatible with various substances. It features a rapid open/close time of less than a second and a lifecycle of over a million cycles. Unique to this series is its low-pressure start feature, enabling it to function with no more than 0.1 bar. The valve incorporates a Viton seal, known for its durability and resistance to high temperatures and corrosive substances. In our latest design, we've successfully reduced redundant volumes and enhanced mechanical strength, resulting in a more efficient and robust product.
Specifications:
Size: 1-1/4"
Body Material: Brass
Flow Aperture: 32 mm
Flow value: 24 Cv
Gasket / Diaphragm / Seal: Viton
Rated Voltage: AC 110 V, ± 10%
Power: 22 VA
Operation Type: Semi-direct Lift Valve
Operation Mode: Normally Closed
Operating Pressure: 0.01-1 Mpa
Operating Temperature: 14 - 302 degrees Fahrenheit (-10 - 150 degrees Celsius)
Wiring: Lead Wire
Suitable Media: Air, water, oil, natural gas, diesel fuel, kerosene etc.
Quality assurance: CE Certified
Valve is not intended to be energized continuously for more than 8 hours. This can lead to burnout of the coil, and malfunctioning of the valve.
CA PROP65 WARNING - This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. They are not allowed by federal law to be installed for potable water use in the U.S.A. and its territories.
Austin
Reviewed in the United States on February 5, 2025
it works, not much else to say.
shelby
Reviewed in the United States on January 22, 2025
Hot water recirculation system as a check valve using recirc pump power to open valve when pump runs.
Charles P.
Reviewed in the United States on January 22, 2025
Works as expected 👌
Dick
Reviewed in the United States on December 20, 2024
110 volt insulated wires exposed without outer cover. Likely a code violation unless in an enclosure. It is unclear whether closing is secure without a pressure difference across the valve.
Recommended Products
